What are flush seawall gas meter isolation pads?

Flush seawall gas meter isolation pads keep the gas meter and related piping accessible for inspection and service without transmitting load or vibration into the cap or the adjacent paver field. The pad stays flush so carts and hoses still cross it, and the surrounding field drains. The utility owns the meter. PaverForge Hardscapes owns the paver bay that lifts later. Call 727-490-9798.

What are flush seawall water meter isolation pads?

Flush seawall water meter isolation pads are custom pads that create a stable, level mounting surface for water meters and utility connections at the seawall. They prevent settlement in coastal soils, improve access for meter reading and service, and maintain a clean flush appearance for Pinellas County waterfront properties.

What are flush seawall utility conduit isolation pads?

A flush utility conduit isolation pad keeps the seawall-cap pavers level around a conduit chase that still has to lift for service. The frame is isolation, not structure for the wall. The marine contractor owns the conduit and the bonding. PaverForge owns the paver bay that stays flush and lifts later. Call 727-490-9798.

Flush Seawall Holding-Tank Vent Collars

paverforge

Oct 8

1 min read

A holding-tank vent that punches a finished seawall cap or a dock-side paver field needs a collar, not a saw-cut patched with mortar. On Pinellas seawalls the vent is small, the cap is the structural edge, and a sloppy penetration becomes the place salt water sits. PaverForge Hardscapes sets flush vent collars so the pipe can be serviced and the paver field still drains.

What the collar is for

The collar is a paver and concrete detail around the vent penetration. It is not a plumbing redesign and it is not a permit for the tank. We coordinate the opening with the marine or plumbing trade that owns the pipe, then build a restrained, pitched collar so washdown water does not run down the vent or pond on the cap.

Opening sized to the existing vent, not guessed from a photo.
Pitch off the penetration so washdown water leaves the collar.
A paver field that can be lifted if the vent fitting is replaced.
No mortar smear across the cap joint that is supposed to move.

How to start

Send a photo of the vent, the cap, and the pavers around it. Call PaverForge Hardscapes at 727-490-9798 or book at https://www.paverforge.com/book-online. We will say whether the collar is a half-day detail or part of a larger cap repair.

Flush Seawall Holding-Tank Vent Collars

What the collar is for

How to start

Recent Posts

Comments