Ground-Mount Pool Solar Collector Rack Pads

Not every pool solar array belongs on the roof. Ground-mount collector racks need a pad that will not sink when the rack is full of water and a storm pushes on the frame. A few pavers laid on sand under the feet will tilt by the next summer.

How we build the rack pad

We size the pad to the rack footprint plus a working margin, undercut organics, and compact crushed concrete in lifts. Pavers or a broom-finish concrete pad can be the wearing surface. The rack anchors go into the structural pad, with a sleeve or block-out so a later panel swap does not mean tearing up the whole field.

Setback matters. Collectors need intake air and a service path, and they should not dump condensate or rinse water onto a light pool deck. We pitch the pad away from the cage and keep it clear of the heater exhaust and the salt-cell waste line.

Start with the rack drawing

Call 727-490-9798 or send the rack cut sheet through the book-online page. PaverForge Hardscapes builds these pads with the surrounding deck work across Pinellas, from St. Pete Beach to Palm Harbor.