Setting a Flush Pool-Cover Pump Vault in a Finished Pinellas Deck

Automatic pool covers collect rain on the lid. The pump that clears that water has to sit near the track, and a box that sticks above the pavers becomes a trip and a mower strike. PaverForge Hardscapes sets a flush vault in the finished deck so the lid is in-plane with the field and the discharge can run to daylight without cutting a new trench later.

Vault, lid, and deck pitch

We coordinate the vault size with the cover contractor before we cut. The box sits on its own compacted pocket, isolated from the pool beam so a later re-level of the deck does not rack the lid. Surrounding pavers pitch away from the track and toward a deck drain or the yard — never back under the cover. If the existing deck is already tight to the beam, we lift a short band, reset bedding, and drop the vault without rebuilding the whole cage floor.

• Flush lid in the same plane as the walking surface

• Isolation from the pool beam and the cover track

• Discharge routed to daylight or a deck drain, not under the cage

• Matching cut units so the vault does not show as a square scar

Do this before the cover goes in

The cheapest time to set the vault is while the deck is open. If the cover is already installed, we still can cut a pocket and reset the band, but the cover has to be parked and protected. Send the cover model and a photo of the proposed corner to PaverForge@gmail.com or call 727-490-9798.

PaverForge Hardscapes sets pool-cover pump vaults on paver decks across Pinellas County, including St. Pete Beach, Seminole, Largo, and Palm Harbor.