Setting a Gas Fire-Table Ring in a Pinellas Paver Patio

A gas fire table looks simple until the ring sits on a sand-set patio that was never built for a concentrated load. PaverForge Hardscapes cuts a dedicated ring, runs a sleeved gas line under the field, and isolates the furniture pad so the rest of the patio does not dish.

The ring is a small foundation

We do not set a 250-pound table on two inches of bedding sand. The ring gets a thicker crushed-concrete pad, a tighter joint, and a level that is checked with the table in place. The field around it stays at the patio pitch so rain still leaves the slider.

The gas sleeve is laid before the field closes. A sweep 90 and a tracer wire beat a later saw cut through finished pavers. Shutoff stays reachable outside the ring, not buried under the burner pan.

• Confirm HOA and city rules for open-flame tables before the gas stub.

• Keep the ring outside the screen-enclosure footer and away from the pool bond beam.

• Use a darker soldier band so soot and chair scuffs hide better.

• Leave two extra units from the same pallet for future face-chip repairs.

Adding a table to an existing patio

We can lift a square, build the pad, and sleeve the line through a short trench if the patio was installed with extra units. If the field is already dished, we re-level that zone at the same time. Call 727-490-9798 or book online. PaverForge Hardscapes sets fire-table rings from St. Pete Beach through Palm Harbor and Dunedin.