Setting a Pool Automation Hub Isolation Pad Beside a Pinellas Cage

Modern Pinellas pools run automation hubs, load centers, and wireless antennas next to the equipment pad. Those enclosures are not happy sitting in splash from the backwash or leaning after the cage footer settles. PaverForge Hardscapes builds a small isolated pad or pedestal for the hub so the electrician can plumb conduit and the homeowner can open the door without standing in a puddle.

Why hubs fail on a shared slab

When the hub shares a pad with the pump, vibration walks breakers and looks like an electrical problem. When it sits on the deck field, cage settlement racks the can and binds the door. Isolation from both the equipment skid and the cage footer solves most of those callbacks.

We also watch splash. Backwash, heater condensate, and tablet-feeder drip all migrate to the lowest corner. The hub pad gets its own pitch and, where the plumber allows it, a simple splash basin that does not wet the enclosure lip.

Build details

The pad is compact: large enough for the can, the conduit sweep, and a service stance. We sleeve low-voltage and line-voltage chases separately when the electrician wants them split. Height is set so the enclosure stays above typical splash and above the finished deck, not buried behind a later soldier course.

If you are upgrading from a time clock to a full automation panel, this is the moment to move the can off the old cracked corner instead of hanging new gear on the same bad plane.

Have the hub pad set before the electrician

Call PaverForge Hardscapes at 727-490-9798 or email PaverForge@gmail.com with the model and a photo of the equipment yard. We will coordinate pad height with your electrician and pool builder.